Zapco Z-series Owner's Manual download pdf (Page 8)

Z-1KD

Z-2KD / Z-3KD

First make the ground connection, then +12V wire connection, and finally the remote connection.

NOTE: The +12V wire must always be fused at the battery for protection against possible

damage. If you need to replace the power fuse, replace it with a fuse of the same value.

It may result in a serious hazard to use a fuse of a different type or rating.

Caution

+12V Power

Disconnect the battery ground, then, connect the +12V terminal of the amplifier to the + terminal of

the battery using the appropriate diameter cable, in-line fuse holder at the battery + terminal.

Remove the fuse from the holder before installation and replace only after all connections are completed.

GROUND

Disconnect the battery and connect the GND (ground) terminal to the cars fame or chassis the same

gauge wire as the positive cable. Keep this cable as short as possible.

Make sure that the connection with the frame of chassis is rust free and clear of paint or grime.

REMOTE

Connect the REM terminal of the amplifier to the power antenna terminal in the car ignition switch

using 142 or 16 ga. electrical wire.

Caution

This amplifier is not supplied with internal

fuseing. Make sure you install an in-line

fuse holder from the +terminal of battery.

Recommend 200 Ampere fuse.(Z-2KD)

Recommend 300 Ampere fuse.(Z-3KD)

to REMOTE Turn-on

from HEAD UNIT

Caution

This amplifier is not supplied with internal

fuseing. Make sure you install an in-line

fuse holder from the +terminal of battery.

Recommend 100 Ampere fuse.

BATTERY

HEAD UNIT

POWER CONNECTION

GROUND

to REMOTE Turn-on

from HEAD UNIT

BATTERY

HEAD UNIT

GROUND

-7-

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Zapco Z-series Owner's Manual Page 8